I replaced the SSD and fan, and now the heatsink pipe lifts when I start tightening its screws. It sits flush with the screws removed. I don't see a bend or obstruction, and the fan cable isn't underneath it. What should I check before putting it back together?
Why won't my Steam Deck heatsink sit flush after a fan swap?
Answers
Don't force the screws down or run the Deck with the heatsink lifted. Back the screws out and check that each one is going into its proper hole without resistance. A screw starting at an angle or catching the wrong threads could pull the assembly out of position.
Set the heatsink in place first, then start the screws loosely and tighten them gradually. If it starts lifting again, stop and note which screw causes it. That should help narrow down where the alignment is off.
Reply to this answer
Since it changed while the fan was being removed, check how the replacement fan is seated. Look around its edges and mounting points, not just under the pipe, for anything holding it slightly high. Compare it with the model-specific repair guide before loosening or moving anything else.
Reply to this answer
A clear photo from the side and another from above would help here. Include the screw positions and where the pipe lifts. It could be an alignment issue even if the pipe doesn't look bent, but there's not enough detail to tell which part is causing it.
Reply to this answer
Add your answer
Answers are reviewed before publication.
Related Discussions