How should I set up VRR, V-Sync, and an FPS cap?

November 17, 2026 4 answers
Asked by LANportRaincheck

I have an AMD GPU and a FreeSync monitor on KDE Plasma with Wayland. VRR is enabled on the monitor, V-Sync is off in games, and I use MangoHud to cap FPS at the monitor's maximum refresh rate. Is that the right setup?

I also switched from a 160 Hz monitor to a 240 Hz one, and 160 FPS feels worse on the new screen. What should I check?

Answers

strafingByForklift

Make sure VRR is enabled for the display in Plasma too, not just in the monitor menu. Then try a cap a few frames below 240 FPS rather than exactly at 240. That leaves some room for fluctuations so the game is less likely to hit the top of the VRR range.

V-Sync off is a reasonable starting point, but watch for tearing near the top of the range. You can also try V-Sync on with the cap below the maximum and compare how it feels. The exact behavior can depend on the game and presentation path.

QCFbyLunchtime:

And check the monitor's VRR range. A cap only helps keep you below the upper limit, not above the lower one.

Reply to this answer
rollbackChk_14

Don't assume 160 FPS will look identical on both displays just because VRR is enabled. Panel response, overdrive settings, and how each monitor behaves at that refresh rate can all affect motion clarity.

First check that the new display is actually running at 240 Hz and that VRR is active while the game is running. If the monitor has a refresh-rate display, see whether it changes with the frame rate. Then try its different overdrive settings at around 160 FPS. Look for smearing or bright trails, not just the FPS number.

Reply to this answer
VHSarcadeKid

A flat FPS reading isn't the whole story. Try a frametime graph and look for spikes while moving around. Shader compilation, CPU load, or the game's frame limiter can cause uneven delivery even when the average is 160 FPS.

If the game has its own limiter, compare it with MangoHud's limiter. Use one cap at a time while testing so you can tell which setting is doing what.

Reply to this answer
deckTechDaypass

VRR is especially handy for a game that needs a fixed cap for physics. A 60 FPS cap can stay in place while the monitor follows the game's output, as long as that rate is within the display's VRR range or the display handles lower rates through frame multiplication.

It isn't a guarantee of perfect pacing, though. A game can still stutter, and fixed refresh with V-Sync can work well in some setups. Test the actual game rather than assuming one combination is best for everything.

Reply to this answer

Add your answer

Answers are reviewed before publication.

Related Discussions