I'm trying to plan a large ring tilted around a cone in a Bedrock creative world. A normal circle guide isn't helping much because the height changes look uneven. How would you lay one out?
How do you make a smooth inclined circle in Minecraft?
Answers
Try laying out the ring from above first, then assign heights to it. Pick two opposite points as the highest and lowest spots, with the other two opposite points halfway between them. The height should change gradually between those points, not rise by the same amount at every block.
For a more precise guide, measure each block's distance from the midpoint along the direction of the slope. Set its height proportional to that distance, rounding to the nearest whole block. Blocks at the same distance along that direction should have the same height. Temporary columns can make it easier to mark those heights before connecting the ring.
Reply to this answer
Another way is to build a flat circle on a temporary surface, then tilt the whole thing using coordinates. For a tilt around the east-west axis, keep each block's east-west position, multiply its north-south distance from the center by the cosine of the tilt angle, and use the sine of that angle for its height offset. Round the results to block positions.
It won't be perfectly smooth on a block grid, and rounding can leave gaps or doubled-up positions. Fill those by eye and check the shape from several angles. A larger ring gives you more room to make the steps look gradual.
Reply to this answer
If the math sounds like a pain, start with four guide points and build one quarter of the ring at a time. Mark the high and low points and the two halfway points, then use temporary blocks to connect them with a gradual curve. Mirror the result for the other half.
Stand back and check it from above and from the side. The block steps don't have to follow an identical pattern all the way around, since the curve changes direction as it rises.
Reply to this answer
Add your answer
Answers are reviewed before publication.
GBAcart!LooseLeaf:
That produces a tilted outline with a circular footprint. If the ring itself needs to be a true circle in its tilted plane, the footprint needs to be squashed in the direction of the slope.