Is a Linux tool for adjusting dead zones, triggers, back buttons, and profiles on 8BitDo controllers feasible? Does it depend on which model you have?
Could there be a Linux tool for configuring 8BitDo controllers?
Answers
It depends a lot on the model. The Ultimate 2 Wireless appears to be a promising candidate because the official configuration software reads and writes a configuration image containing profiles, button maps, macros, and stick, trigger, and vibration settings.
The image layout has been recovered from the software binaries, but it still needs checking against an image read from an actual controller. That is a step toward a tool, not proof that configuration writes are ready or safe.
Reply to this answer
The Ultimate 2C looks like a different story. Analysis of its firmware found no host-side configuration channel for those settings. Its back-button bindings appear to be stored on the controller and changed with the on-controller button combination, rather than through a desktop tool.
The dongle was not found to relay configuration commands either. So support for the Ultimate 2 Wireless would not automatically mean support for the 2C.
Reply to this answer
For testing, start with inventory and read-only access before even considering writes. The proposed reader restricts outgoing packets to an allowlist and refuses write, commit, firmware, and bootloader commands. If you want to help, review the tool and its tests yourself before running it, and check the output before sharing it.
P8airDashReceipt:
The proposed read test is for an Ultimate 2 Wireless connected by cable in DInput mode. The project also asks for a device permission rule.
Reply to this answer
Add your answer
Answers are reviewed before publication.
P6airBrake!Perhaps:
So the layout is understood in theory, but still needs a real controller dump to verify it?
speedrunRouteMisdial:
Right. Comparing a readout with known settings would help check whether the fields have been interpreted correctly.