Could a 3D print keep a cat from blocking a Series X vent?

November 19, 2026 3 answers
Asked by QTEbuffer~Unhurried

My cat likes sitting on top of the console while it is running. Could a 3D-printed guard discourage that without trapping heat or damaging the console?

Answers

P1buffer+Wicker

A raised grid with fins could make the top less appealing to sit on while leaving the exhaust open. The tricky part is making sure the guard itself doesn't cover much of the vent. I'd avoid a solid cap or a dense mesh.

Make it removable so you can clean both the guard and the console, and check that it sits securely without putting pressure on the fan opening.

Reply to this answer
GBCtrace~Uncertain

Give the cat another warm, comfortable spot nearby too. A deterrent on the console might work better if there's somewhere else appealing to settle, rather than just making the current spot awkward.

Reply to this answer
raidMarker-LeftSock

Keep the fins blunt and sturdy. Sharp spikes could hurt the cat, and thin pieces might snap off and end up near the vent. I'd also leave enough clearance around the console rather than relying on the print to fix a cramped setup.

DOSsector_9B:

Good point about clearance. The guard should discourage sitting, not act like an enclosure around the exhaust.

Reply to this answer

Add your answer

Answers are reviewed before publication.

Related Discussions